Micro Swiss All Metal Hotend Kit for Flashforge

Micro Swiss All Metal Hotend Kit for Flashforge

The Micro Swiss All Metal Hotend Kit for Flashforge consists of 1 Plated Brass Wear Resistant Nozzle, 1 Thermal Tube and 2 Jam Nuts.

29,97 EUR39,97 EUR-25%
In stock
Manufacturer Part No: M2575-04
All prices have the tax included.

Key features:

This is an all metal hotend upgrade kit for Flashforge Finder and Flashforge Guider 2S.  All metal hotend will let you print at a much higher temperature than possible with the original PTFE-lined one. Another benefit of an all-metal hotend design is more consistent melt chamber control. During a slow extrusion rate, in PTFE lined hotend, the transition zone from solid to molten plastic tends to creep upward creating more stringy prints. With all metal design, a transition zone is always constant, being located right at the heat break. With a fast extrusion rate, the PTFE tube doesn’t have enough thermal conductivity to properly melt all the plastic coming out.  All metal hotend solves this problem, plastic is surrounded by a thermally conductive nozzle throughout its length.

Suitable for the following 3D printers:

  • FlashForge Finder
  • FlashForge Inventor 2
  • FlashForge Guider 2 (Older version, without metal plate over the heater block)
  • FlashForge Guider 2S
  • Dremel 3D40 Idea Builder

Installation:

 

Customer reviews

Others also bought

In stock
From 9,90 EUR
This product has multiple variants. The options may be chosen on the product page
In stock
From 9,90 EUR
This product has multiple variants. The options may be chosen on the product page
In stock
From 9,90 EUR
This product has multiple variants. The options may be chosen on the product page
In stock
From 9,90 EUR
This product has multiple variants. The options may be chosen on the product page